在行駛中或啟動時發現自動攪拌車車輪有異常響聲，要及時檢查軸承及剎車系統是否有故障。如果車輪運轉不正常，就會影響車速，從而使油耗加大。離合器打滑會使動員機的轉速降低。當您在急加速時發現動員機轉速表增加很快，但車速增加卻很慢，這時可以鑒定是離合器打滑了。
If the wheels of the automatic mixer truck make abnormal noises during driving or starting, it is necessary to promptly check whether the bearings and brake system have faults. If the wheels do not operate properly, it will affect the vehicle speed and increase fuel consumption. Clutch slippage will reduce the rotational speed of the mobilization machine. When you accelerate rapidly, you notice that the speed indicator of the mobilization machine increases rapidly, but the vehicle speed increases slowly. At this time, it can be identified that the clutch is slipping.
自動攪拌車火花塞使用的時間太長，也會出現油耗加大的現象。因為火花塞損壞會使焚燒的能量下降，使攪拌車提速減慢，導致柴油耗損明顯增加，只要更換火花塞就好了。
If the spark plug of an automatic mixer truck is used for too long, it can also cause increased fuel consumption. "Damage to the spark plug can reduce the energy used for incineration, slow down the speed of the mixer truck, and significantly increase diesel consumption. Simply replace the spark plug.".
當自動攪拌車的溫控開關和節溫器損壞時，會呈現油耗增加的現象。因為溫控開關和節溫器損壞會使水溫低落，化油器不能正常工作，導致混凝土攪拌車霧化不良，油耗量明顯增加。長時間行駛時，凡是會出現汽缸壓力不符的現象，這時油耗也會明顯增加。同時如果出現這種情況，那么就需要大修了。
When the temperature control switch and thermostat of an automatic mixer truck are damaged, fuel consumption will increase. Due to damage to the temperature control switch and thermostat, the water temperature will drop and the carburetor will not work properly, resulting in poor atomization of the concrete mixer truck and a significant increase in fuel consumption. When driving for a long time, there is usually a phenomenon of inconsistent cylinder pressure, at which time the fuel consumption will also significantly increase. At the same time, if this happens, then an overhaul is needed.
自動攪拌車使用中要注意的問題
Problems needing attention in the use of automatic mixer trucks
1、自動攪拌車應停入在平地上，并將鏟斗平放地面。當發動機熄火后，需反復多次扳動工作裝置操縱手柄，確保各液壓缸處于無壓休息狀態。當自動攪拌車只能停在坡道上時，要將輪胎墊牢。
1. The automatic mixer truck should be parked on a flat ground and the bucket placed flat on the ground. After the engine shuts down, it is necessary to repeatedly pull the operating handle of the working device several times to ensure that each hydraulic cylinder is in a pressure free rest state. When the automatic mixer truck can only be parked on a ramp, it is necessary to pad the tires firmly.
2、自動攪拌車在停止工作后操作人員將各種手柄置于空擋或中間位置。
2. After the automatic mixer stops working, the operator places various handles in the neutral or intermediate position.
3、先取走電鎖鑰匙，然后關閉電源總開關，后關閉門窗。
3. First remove the electric lock key, then turn off the main power switch, and then close the doors and windows.
4、自動攪拌車嚴禁停在有明火或高溫地區，以防輪胎受熱爆炸，引起事故。
4. Automatic mixer trucks are strictly prohibited from parking in areas with open flames or high temperatures to prevent tires from exploding due to heat and causing accidents.
5. When using a combination valve or air reservoir to inflate a tire, one should not stand on the front of the tire of the automatic mixer to prevent explosion and injury. For more relevant content, please visit our website http://www.top2010.cn Consult!
上一篇：攪拌車的空調濾清器使用注意事項
下一篇：自動攪拌車的一些維護保養內容
